Directions:
1. Gather the following
materials:
A Piece of Cardboard or Posterboard Large Paper
Fastener Scissors Glue Mirror Tape 2 Washers Spinning Disc Pattern Dancing Line Sheet Flower in a Hat Sheet Stick
Figure Doing Sit-ups Sheet
2. Glue the Spinning
Disc Pattern onto a piece of cardboard. Cut out the circle and cut out the gray
areas to make slits.
3. Glue (or tape) a washer in the center of the
Disc, one washer on each side.
4. From the cardboard, cut two strips,
each about 2 inches wide and 12 inches long.
5. Place one strip on top of
the other, and tape them together at one end. Wrap the tape about 4 inches up
the strips.
6. Put the Disc between the open ends of the cardboard
strips.
7. Secure the Disc in place, about 1 inch down from the edge of
the strips, using the paper fastener (poke it through all three layers of
cardboard, making sure it goes through the center of the disc).
8.
Choose one of the sample sheets (The Dancing Line, The Flower in the Hat, or The
Stick Figure Doing Sit-ups). Cut out each image and glue it, in a clockwise
direction, between the slits on the spinning disc. Try to position the dot (it
is in the upper right hand corner of each image) in the same spot.
9.
Hold the Spinning Disc up to the mirror with the pictures facing the mirror.
Look through the top slit and spin the disc. (If it does not spin freely, loosen
the paper fastener). |
|
| What do you see? | |
|
| How can I get credit for this
assignment? | |
|
| Back to Ms. Gould's Bonus Page | |